motor and 138.0 for a transmission line. For a
transformer, report the highest voltage rating. For
single phase devices (reactors, power, or instrument
transformers) Indicate the nominal three-phase voltage
of the circuit to which the device Is connected.
Insert the current rating In amperes as shown on the
primary equipment nameplate. For multiratio current
transformers, insert the rating corresponding to the
highest available ratio; for example, a transformer
connected 200/5 amps, but with maximum rating of
600/5, would be reported as 600.
Indicate the numerical value of the primary equipment
capacity, such as 250 or 75000. For equipment with
more than a single rating, such as transformers with
one or more stages of supplemental cooling, report
the largest rating. For instrument transformers, these
boxes should be left blank.
Unit of Measurement
Indicate the units in which the capacity is measured
(KW, KVA, KVAR, HP, etc.). The rating of generators
must be In KW; of pumps, turbines, and motors In HP;
of circuit breakers and power transformers in three-
phase KVA; of condensers, in three-phase KVAR;
and of capacitors and reactors in single phase KVAR.
Provide the specification, invitation, or solicitation
number under which the primary equipment was
furnished, if available.
Show "WBR," unless equipment is owned by others
with O&M provided by Reclamation, In which case
indicate ownership using approved codes in section 2.9,
"OWNERS, ALL REGIONS," of
Component in Trouble
Report the name of the faulty component on the line
equipment being covered by the report.
(FIST 1-3 12/89)