When the report is forwarded by a transmittal letter
which contains additional data, or which requests
comments or action by the Denver Office, place a "Y"
("yes") in the box. Otherwise, place an "N" ("no") in
Report the primary, equipment name on the line
provided, and insert the approved code shown in
equipment to only those items listed in left-hand
columns of section 5.3, "PRIMARY EQUIPMENT AND
COMPONENT CODES," of
Operating No. or
Insert the assigned operating number or device
designation of the primary equipment being reported,
if one exists.
Insert the last two numbers of the calendar year when
the primary equipment was installed at that location.
In many instances, this information is available from
the PLS Listing. In case the equipment had been
previously installed at a different location, provide
details (where and when) in "Remarks" portion of the
Report the name of the primary equipment manufac-
turer on the line provided, and insert the corresponding
code as shown in section 5.4, "MANUFACTURER'S
NAME CODES," of
Insert the manufacturer's designated type of the
equipment as indicated on the equipment nameplate.
It is essential that any characters such as decimal
point, comma, dash, diagonal slash mark, etc., be
included in this identification. If the designation has
too many characters to fit in the boxes provided,
show the type designation in the "Remarks" section.
On the line provided, insert the serial number
indicated on the nameplate of the primary equipment
involved, if one exists.
Provide applicable basic ratings of the primary
equipment (voltage, current, and capacity) as follows:
Insert the nominal voltage, in kilovolts. The voltage
reported should be placed to fill the right-end boxes,
recognizing the decimal point preceding the far-right
box; for example, differentiate between 13.8 for a
59 (FIST 1-3 12/89)